Using The Toolbar - Ametek L Series User Manual

L-Series and FCS-18- Graphical User Interface User Manual

4.7 Using the Toolbar

The toolbar provides a convenient shortcut for mouse savvy operators.
Clicking on each of the toolbars icons will cause the corresponding menu and
sub-menu to be selected at once. The following toolbar icons and their
corresponding menu equivalents are provided :
Icon
30
Menu equivalent
File-New
File-Open...
File-Save
Configuration-Model
Configuration-System Settings...
Configuration-IEEE Interface...
Source-Initialization...
California Instruments
Description
Resets all setup information to default values. If
an actual L-Series is connected to the PC,
hardware configuration data remains
unchanged.
Opens the File Open dialog box. User can select
setup file to load.
Save present settings to disk setup file. If no
setup was loaded previously, the File Save As...
dialog box will appear prompting the user for a
name to save the setup under. If a setup file was
opened previously, the new settings will be used
to overwrite the same setup file. To avoid this,
use the File Save As... menu instead.
Allows different L series models to be selected
for simulation purposes. Model can only be
changed when in simulation mode.
Shows installed options and hardware
configuration. Also provides access to output
and measurement calibration screens.
Opens the IEEE interface setting and command
line screen. This screen can be used to change
the IEEE address used to communicate with the
L-Series AC source. An interactive command
line is provided as well to allow the user to send
IEEE commands directly to the instrument. All L-
Series APE commands are available from a drop
down list.
Opens the initial settings window. This window is
used to inspect and change the initial power up
settings.
Rev D – March 2011