Ametek L Series User Manual page 102

L-Series and FCS-18- Graphical User Interface User Manual
Your PC may have conflicts on the Base I/O address, the IRQ and or the
DMA. There is no way for us to determine this. If you run into this, try to
experiment with different Base I/O address until you find one that works. In
most cases, the default 0x2c0 should work. If you can't find a suitable IRQ
and DMA channel, you can disable them. The LSGUI software does not
require IRQ or DMA operation.
NOTE : Make sure to check the "Assert REN When SC" selection in the
lower right corner. This allows the GPIB card to take control of the bus
when directed to do so from the LSGUI program.
4.
and restart it to make the settings active.
5.
the NI software setup and select the Hardware Diagnostic Test Icon. This
allows you to run the hardware diagnostics.
98
Once the correct configuration has been set, you need to exit windows
Now open the NI-488.2 SOFTWARE group that was created during
California Instruments Rev D – March 2011