Ametek L Series User Manual page 104

L-Series and FCS-18- Graphical User Interface User Manual
This test should pass. If not, call National Instruments for Help.
7.)
Connect the cable between the PC IEEE port and the L Series source. Set
the IEEE address on the L Series unit and start the L Series GUI. If the
source is not found, at startup, go to the interface screen and take the
program out of simulation mode. Select the IEEE address for the L Series
and press the OK button. This should establish communication. If this fails,
repeat step 6 and try again.
100
If all the above tests passed, you are ready to run the L Series GUI.
California Instruments Rev D – March 2011