Requirements - Ametek L Series User Manual

2. Requirements

To successfully install and operate the LSGUI program, you will need the
following equipment :
L-Series AC power source. Supported models are :
1501L
1503L
2000L
2750L
4500L
• -P or -PT programmable controller. Manual controller (Type -M) equipped
L-Series AC sources can not be operated by this program. Contact
California Instruments for information on upgrading to a -P or -PT
controller.
• PC capable of running Windows 3.1™, Windows for Workgroups 3.11™
or Windows 95™
• National Instruments PC/IIA or PC-AT/TNT IEEE interface card. Other
vendor IEEE interface cards are not supported unless they are
compatible at the DLL level
• IEEE Cable
Note that the LSGUI can
be run in the absence of an
L-Series power source. If no
AC source is available or a
suitable IEEE controller card
cannot be found, the LSGUI
can be operated in a
simulation mode. The
program will detect these
conditions and start up in
simulation mode after n
be simulated and should not be used for any analytical purpose.
1
This model is not available at this time and is supported for future compatibility only.
2
DLL compatibility implies identical functional calls and parameters as the National Instruments GPIB.DLL.
Rev D – March 2011
L-Series and FCS-18 Graphical User Interface User Manual
9000L
12000L
13500L
1
18000L
2
.
otifying the operator. Measurements in this case will
California Instruments
751L 6000L
11