Transient Execution - Ametek L Series User Manual

L-Series and FCS-18- Graphical User Interface User Manual

7.7 Transient execution

Transient execution can be started by clicking on the
button. The register shown in the "Start from Reg:" drop down list will be the
first one executed. Select the desired register number before pressing the
proceed according to the link sequence. (Refer to section 7.3)
The
may not always work immediately and an error message may pop up
indicating the attempt to stop the transient in progress was unsuccessful.
Clicking the
66
button. If this register is linked to other registers, execution will
button can be used to stop transients in progress. This
button several times usually resolves this problem.
California Instruments Rev D – March 2011