Measurement Modes - Ametek L Series User Manual

8.2 Measurement modes

Two measurement modes are supported by the LSGUI
program. They are both selected from the measurement window
using the Mode field located on the right hand side of the
window. The following modes are available :
Run Once mode
Cycle mode
Rev D – March 2011
L-Series and FCS-18 Graphical User Interface User Manual
This mode will cause all measurements to
be taken once when the
clicked. Once a cycle has been started, it will run
through completely, even if the
clicked. This is to avoid incomplete measurement
records when the data logging function is enabled.
In this mode of operation, measurements are taken
continuously. This mode of operation is required for data
logging applications. It is selected automatically when
the data logging function is enabled. The cycle mode is
started using the
button.
California Instruments
button is
button is
button and stopped using the
69