Ametek L Series User Manual page 101

2.
drivers using the Windows disk. The DOS drivers are not required but may
be installed if desired. This is done by running the Setup program from the NI
disk labeled "NI-488.2 Software for Windows, Distribution Disk for the EISA-
GPIB, the AT-GPIB/TNT, and the AT-GPIB" or the equivalent disk supplied
with the PC/IIA card.
3.
and select the GPIB icon (NI logo). This brings up the hardware configuration
screen. Use the settings shown below:
Rev D – March 2011
L-Series and FCS-18 Graphical User Interface User Manual
Next, install the National Instruments GPIB-TNT or PC/IIA Windows
Once the installation is completed, open the Windows Control panel
California Instruments 97