Verify Phone Startup - Cisco 7800 Series Administration Manual

Verify Phone Startup

Entry
IPv6 Default Router
IPv6 DNS Server 1
IPv6 Alternate TFTP
IPv6 TFTP Server 1
IPv6 TFTP Server 2
IPv6 Address Released
Verify Phone Startup
After the Cisco IP Phone has power connected to it, the phone automatically cycles through a startup diagnostic
process.
Procedure
Step 1 If you are using Power over Ethernet, plug the LAN cable into the Network port.
Step 2 If you are using the power cube, connect the cube to the phone and plug the cube into an electrical outlet.
The buttons flash amber and then green in sequence during the various stages of bootup as the phone checks
the hardware.
If the phone completes these stages successfully, it has started up properly.
Related Topics
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
52
Type
Startup Problems, on page 191
Default value
::
::
No
::
::
No
Cisco IP Phone Installation
Description
Displays the default router used
by the phone or allows the user
to enter a new IPv6-only default
router.
Displays the primary DNSv6
server used by the phone or
allows the user to enter a new
server.
Allows the user to enable the
use of an alternate (secondary)
IPv6 TFTP server.
Displays the primary IPv6 TFTP
server used by the phone or
allows the user to set a new
primary TFTP server.
(Optional) Displays the
secondary IPv6 TFTP server
used if the primary IPv6 TFTP
server is unavailable or allows
the user to set a new secondary
TFTP server.
Allows the user to release
IPv6-related information.