Set Tftp Server 2 Field; Verify Phone Startup; Configure Phone Services For Users - Cisco 7821 Administration Manual

Set TFTP Server 2 Field

Procedure
Step 1
Unlock administrator password setting.
Step 2 Enter an IP address for the TFTP Server 1 option.
Step 3 Press Back, scroll to the TFTP Server 2 option, press Select, and enter a new backup TFTP server IP address.
If there is no secondary TFTP Server, you can use Delete to clear the field of a previous value.
Step 4
Press Apply to apply the changes or Revert to discard the changes.

Verify Phone Startup

After the Cisco IP Phone has power connected to it, the phone automatically cycles through a startup diagnostic
process.
Procedure
Step 1
If using Power over Ethernet, plug the LAN cable into the Network port.
Step 2 If using the power cube, connect the cube to the phone and plug the cube into an electrical outlet.
The buttons flash amber and then green in sequence during the various stages of bootup as the phone checks
the hardware.
If the phone completes these stages successfully, it has started up properly and the Select button stays lit until
it is selected.
Related Topics
Startup Problems, on page 177
Cisco IP Phone Does Not Go Through Normal Startup Process, on page 177

Configure Phone Services for Users

You can give users access to Cisco IP Phone Services on the IP phone. You can also assign a button to different
phone services. The IP phone manages each service as a separate application.
Before a user can access any service:
• You must use Cisco Unified Communications Manager Administration to configure services that are
• The user must subscribe to services by using the Cisco Unified Communications Self Care Portal. This
not present by default.
web-based application provides a graphical user interface (GUI) for limited, end-user configuration of
Cisco IP Phone 7821, 7841, and 7861 Administration Guide for Cisco Unified Communications Manager 10.0 (SIP)
Verify Phone Startup
43