Cisco 7800 Series Administration Manual page 114

Telephony Features for the Cisco IP Phone
Feature
Private Line Automated Ringdown
(PLAR)
Problem Report Tool (PRT)
Programmable Feature Buttons
Quality Reporting Tool (QRT)
Recents
Redial
Reroute Direct Calls to Remote
Destination to Enterprise Number
Remote Port Configuration
Ringtone Setting
RTCP Hold For SIP
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
100
Description and More Information
The Cisco Unified Communications Manager administrator can configure a phone number
that the Cisco IP Phone dials as soon as the handset goes off hook. This can be useful for
phones that are designated for calling emergency or "hotline" numbers.
See directory number information in the documentation for your particular Cisco Unified
Communications Manager release.
Submit phone logs or report problems to an administrator.
See Problem Report Tool, on page
You can assign features, such as New Call, Call Back, and Forward All to line buttons.
Note The Cisco IP Phone 7811 does not support this feature.
See phone button templates in the documentation for your particular Cisco Unified
Communications Manager release.
Allows users to submit information about problem phone calls by pressing a button. QRT can
be configured for either of two user modes, depending upon the amount of user interaction
desired with QRT.
Allows you to enable/disable the Recents softkey on a phone.
Allows users to call the most recently dialed phone number by pressing a button or the Redial
softkey.
Reroutes a direct call to a user's mobile phone to the enterprise number (desk phone). For an
incoming call to remote destination (mobile phone), only remote destination rings; desk phone
does not ring. When the call is answered on their mobile phone, the desk phone displays a
Remote In Use message. During these calls, users can make use of various features of their
mobile phone.
See Cisco Unified Mobility information in the documentation for your particular Cisco Unified
Communications Manager release.
Allows you to configure the speed and duplex function of the phone Ethernet ports remotely
by using Cisco Unified Communications Manager Administration. This enhances the
performance for large deployments with specific port settings.
If the ports are configured for Remote Port Configuration in Cisco Unified
Note
Communications Manager, the data cannot be changed on the phone.
See Remote Port Configuration,
Identifies ring type used for a line when a phone has another active call.
See directory number information in the documentation for your particular Cisco Unified
Communications Manager release and
Ensures that held calls are not dropped by the gateway. The gateway checks the status of the
RTCP port to determine if a call is active or not. By keeping the phone port open, the gateway
will not end held calls.
138.
Product Specific Configuration, on page 106
Custom Phone Ringtones, on page
Cisco IP Phone Administration
.
83.