Cisco 7800 Series Administration Manual page 123

Cisco IP Phone Administration
Field Name Field Type
or Choices
Backlight Idle hh:mm
Timeout
Backlight On When Disabled
Incoming Call
Enabled
Enable Power Save Days of the week
Plus
Default
Enabled
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
Description and Usage Guidelines
Defines the length of time that the phone is idle before the
backlight turns off. Applies only when the backlight was off
as scheduled and was turned on by a user (by pressing a button
on the phone or lifting the handset).
For example, to turn the backlight off when the phone is idle
for 1 hour and 30 minutes after a user turns the backlight on,
enter 01:30.
Turns the backlight on when there is an incoming call.
Defines the schedule of days for which the phone powers off.
Choose the day or days from the drop-down list. To choose
more than one day, Ctrl+click each day that you want.
When Enable Power Save Plus is turned on, you receive a
message that warns about emergency (e911) concerns.
Caution While Power Save Plus Mode (the "Mode") is in
effect, endpoints that are configured for the mode
are disabled for emergency calling and from
receiving inbound calls. By selecting this mode, you
agree to the following: (i) You take full
responsibility for providing alternate methods for
emergency calling and receiving calls while the
mode is in effect; (ii) Cisco has no liability in
connection with your selection of the mode and all
liability in connection with enabling the mode is
your responsibility; and (iii) You fully inform users
of the effects of the mode on calls, calling and
otherwise.
To disable Power Save Plus, you must uncheck the Allow
EnergyWise Overrides check box. If the Allow EnergyWise
Overrides remains checked but no days are selected in the
Enable Power Save Plus field, Power Save Plus is not disabled.
Product Specific Configuration
109