GRAPHTEC FC5100A-75 User Manual page 90

90
NOTE:
1
2
3
CAUTION: If the media is loaded at an angle, make sure that it does not come loose from
Ad v an ce d Fu n ct i on s an d S e t ti ng s : A X IS A LI G NM E NT - Ax is Al ig n me n t P ar a m et er S et t in g
The Axis Alignment settings are cancelled if any of the following operations are
performed:
A new Origin is set
The media is reloaded
Rotation and/or Mirror settings are made (make these settings before perform-
ing axis alignment).
If the axis is slanted too much between points 1 and 2, 1 and 3, 3 and 4, and 2
and 4, an axis error message is displayed. Reload the media to reduce the axis
slant.
If points 1 and 2 are specified as the same point, the axis alignment settings
are cleared.
the pinch rollers while it is being moved.