GRAPHTEC FC5100A-75 User Manual page 117

Press the POSITION key to move the pen and media to the area necessary for
scanning the first registration mark. When using AUTO scan mode, move the
media to the first registration mark that is located between the pinch roller and the
pen.
Pattern 1
Mark 4
Left pinch
roller
Mark 3
When using MANUAL scan mode, move the pen and the media to the square
area that is created by the first registration mark.
Pattern 1
Mark 4
Left pinch
roller
Mark 3
After setting the location of the registration mark, press the F3 key or F4 key to
select AUTO to automatically read the registration marks, or MANUAL to set the
starting point to manually read the registration marks. The plotter starts searching
or scanning for the first registration mark.
• When you select the auto distance adjustment for the 5, 10, or 50 mm resolution
mode, the plotter reads the distance between the registration marks and then
automatically aligns the axes and adjusts the distance.
Ad v an ce d F un c ti on s an d S e t ti ng s : A UT O REG . M A R K - Au t o Re gi st r a ti on M ar k S en so r
Mark 2
Right pinch
Media feed
roller
direction
Mark 1
The pen moves
on this line.
Mark 2
Right pinch
roller
Mark 1
Move the pen
into this area.
Pattern 2
Mark 4
Left pinch
roller
Mark 3
The pen moves
on this line.
Pattern 2
Mark 4
Media feed
Left pinch
direction
roller
Mark 3
Move the pen
into this area.
117
Mark 2
Right pinch
roller
Mark 1
Mark 2
Right pinch
roller
Mark 1