GRAPHTEC FC5100A-75 User Manual page 118

118
After all the registration marks are read, the plotter moves the pen and media to
the AXIS ORIGIN POINT. The axis origin location is set in the AXIS ORIGIN OFF-
SET menu and then the READY menu appears.
• When you disable auto DISTANCE ADJustment, the following menu appears
after the plotter scans the registration marks:
The measured distance between registration mark 1 and mark 2 is shown on the
third row. If the distance between the marks is a known value, set the actual dis-
tance on the fourth row. Press the RIGHT or LEFT ARROW key to move the blink-
ing cursor and press the UP or DOWN ARROW key to change the number for
setting the actual distance.
• Press the ENTER key to store the setting.
• When selecting the 2-POINTS scan mode, the plotter moves the pen and media
to the AXIS ORIGIN point. The AXIS ORIGIN OFFSET menu is used to set the
AXIS ORIGIN point location; the READY menu then appears.
• When selecting the 3-POINTS or 4-POINTS scan mode, the following menu
appears:
The measured distance between registration mark 1 and mark 3 is shown on the
third row. If the distance between the marks is a known value, set the actual dis-
tance on the fourth row. Press the RIGHT or LEFT ARROW key to move the blink-
ing cursor and press the UP or DOWN ARROW key to change the number for
setting the actual distance.
• Press the ENTER key to store the setting.
When selecting the 3-POINTS scan mode, the plotter moves the pen and media
to the AXIS ORIGIN point. The AXIS ORIGIN OFFSET menu is used to set the
AXIS ORIGN point location, the READY menu then appears.
In the 4-POINTS scan mode, the pen is moved to the first point.
Ad v an ce d Fu n ct i on s an d S e t ti ng s : A UT O R E G . M A RK - Au t o Re gi st r a ti on M ar k S e n so r
DISTANCE
POINT 1-2
00302.0
OK?....... .00302.0
DISTANCE
POINT 1-3
00302.0
OK?.. .......00302.0
mm>*
mm>*
mm>*
mm>*