Pen Select - GRAPHTEC FC5100A-75 User Manual

138

Pen Select

Ba ck gr ou n d S e tt in g s: B ack g r o un d S e t ti ng s f or G P - G L
is turned off, the registered conditions by command input from the computer are
not retained. The registered conditions by the plotter's control are retained.
• Press the F3 key to select MANUAL or press the F4 key to select PROGRAM. A
blinking cursor appears beside your choice.
• Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
This setting is availabe when the 2 Pen option is installed. The 2 Pen option
installed machine can hold one blade or pen in the pen holder on the pen carriage
(which is referred to as PEN 1) and one pen in the pen holder on the right side
plate (which is referred to as PEN 2).
This function enables or disables the PEN SELECT command ("J" Command in
GP-GP or the "SP" command in HP-GL).
The CONDITION PRIORITY is not affected by this setting.
When ENABLE is selected, the plotter changes pen either by the plotter's con-
trol panel or by command input from the computer.
When DISABLE is selected, commands specifying the pen number from the
computer is ignored.
• Press the F3 key to select ENABLE or press the F4 key to select DISABLE. A
blinking cursor appears beside your choice.
CONDITION PRIORITY
MANUAL
PROGRAM
PEN SELECT
ENABLED
DISABLED
PEN SELECT
ENABLED
DISABLED
.
.
.
.
.
.