GRAPHTEC FC5100A-75 User Manual page 120

120
The FEED LENGTH can be set in a range of 1 to 50 meters. If the feed length is
set too high (too long), the media will unwind. Unwound media will not cut as eas-
ily as wound media.
• Press the ENTER key to register your settings or press the MENU key to
cancel MENU mode.
NOTE:
You may access the auto pre-feed menu from the initial menu which appears on
the LCD when the paper set lever is lowered.
• Press the F4 key to select the initial menu while the initial menu appears on
the LCD.
• Press the F2 key to select AUTO PRE-FEED.
• Press the F3 key to select ENABLED or press the F4 key to select DIS-
ABLED.
If the F3 key is pressed, the following menu will appear:
• Press the UP or DOWN ARROW to lengthen or shorten the FEED LENGTH.
The menu will cycle through the available lengths in sequence.
• Press the ENTER key to store the setting. The following menu appears:
Ad v an ce d Fu n ct i on s an d S e t ti ng s : A UT O P RE - F E E D - A d va nc in g t h e M ed ia A ut o m at ic all y
The plotter begins pre-feeding as soon as the cutting data is sent from the PC
when the auto pre-feed is enabled AND the new origin point is within 50mm of
the previous feed's border.
LOAD MEDIA!
INITIAL FEED
AUTO PRE FEED
AUTO PRE FEED
FEED LENGTH= 1 m
INITIAL FEED
INITIAL MENU>.
.
AUTO PRE FEED>.
SPEED>.
INTERFACE>.
ENABLED *
DISABLED *
.
AUTO PRE FEED>.
SPEED>.
INTERFACE>.