GRAPHTEC FC5100A-75 User Manual page 100

100
• If you press the F3 key (AUTO), sensing begins from the current pen position.
Use the POSITION key to move the pen tip to the shaded area in the following
diagrams, and then press the F3 key.
Move the pen tip within this area
• If you press the F4 key (MANUAL), the following message is displayed. Use the
POSITION key to move the pen tip to MARK 1, and then press the ENTER key.
When the ENTER key is pressed, the plotter will start scanning for the registra-
tion mark.
• When the three points have been scanned, the display changes to the following
(only displayed if OFF has been selected for DISTANCE ADJUST). The mea-
sured value for the distance between points 1 and 2 is shown on the 3rd row.
Set the actual distance on the 4th row.
Press the RIGHT or LEFT ARROW key to move the cursor. Press the UP or
DOWN arrow key to increase or decrease the number for the distance value.
• Press the ENTER key to store the setting. The display changes to the following
(only displayed if OFF has been selected for DISTANCE ADJUST). The mea-
Ad v an ce d Fu n ct i on s an d S e t ti ng s : A UT O R E G . M A RK - Au t o Re gi st r a ti on M ar k S e n so r
Pattern 1
Point 2
Point 1
(the desired Origin Point)
Point 3
MOVE TO MARK
USE THE POSITION
TO MOVE THE PEN
THEN PRESS
DISTANCE
POINT 1-2
OK?..........
Pattern 2
Point 2
Point 1
(the desired Origin Point)
Point 3
Move the pen tip within this area
1*
KEY*
AND*
ENTER.*
00099.8 mm.
00100.0 mm.