GRAPHTEC FC5100A-75 User Manual page 104

104
• Press the F3 key to select ENABLED. A
ting
• Press the ENTER key to register your setting and display the following screen.
• Select 2, 3, or 4 and then press the ENTER key to advance to the next menu.
• Press the F1, F2 or F3 key to select the number you wish to store the settings
under.
• Press the F3 key or the F4 key to select the axis for setting the distance.
• Press the LEFT or RIGHT ARROW key to move the blinking cursor for selecting
the digit, and then press the UP or DOWN ARROW key to change the number.
• The value representing the distance between registration mark 1 and mark 2 is
stored in the X-axis. The value representing the distance between registration
mark 1 and mark 3 is stored in the Y-axis.
Ad v an ce d Fu n ct i on s an d S e t ti ng s : A UT O R E G . M A RK - Au t o Re gi st r a ti on M ar k S e n so r
MARK SCAN MODE
MARK SCAN MODE
A mark appears next to the current setting.
SCAN MARK
MARK POSITION
mark appears next to the current set-
ENABLED *
DISABLED *
2POINTS *
3POINTS *
4POINTS *
........ .. 1>.
2>.
3>.
X = ...0000 mm*.
Y = ...0000 mm*.