Steering Stem Installation - Honda PCX150 2013 Service Manual

FRONT WHEEL/SUSPENSION/STEERING
INSTALLATION
• Always replace the steel balls and races as a set.
LOCK NUT
-~1'.'t:1:11 :
Grease with extreme pressure agent
(recommended: EXCELIGHT EP2
manufactured by KYODO YUSHI, japan
or Shell ALVANIA EP2 or equivalent)
TOP THREAD \
~
UPPER INNER RACE.
--==-----c:-
I
LOWER BEARING (29)
DUST SEAL
I
STEERING STEM
Apply 3 - 5 g of grease with extreme pressure agent
(recommended: EXCELIGHT EP2 manufactured by
KYODO YUSHI, japan or Shell ALVANIA EP2 or
equivalent) to the lower bearing races.
Attach the steel balls (29 balls) [1] to the lower bearing
outer race.
Insert the steering stem [2] into the steering head pipe,
being careful not to drop the steel balls.
Apply 3 - 5 g of grease with extreme pressure agent
(recommended: EXCELIGHT EP2 manufactured by
KYODO YUSHI, japan or Shell ALVANIA EP2 or
equivalent) to the upper bearing races.
Install the steel balls (23 balls) [1] onto the upper
bearing outer race.
Install a upper bearing inner race [2] onto the stem.
~"",
I
LOWER OUTER RACE
0
1