Continuity Inspection - Honda PCX150 2013 Service Manual

ELECTRIC STARTER
6-10
RELAY COIL LINE INSPECTION
(AFTER '13 MODEL)
Disconnect the ECM 33P (Black) connector (page 4-
49).
Turn the ignition switch ON.
Squeeze the rear brake lever fully and push the starter
switch.
Measure the voltage between the ECM 33P (Black)
connector [1] of the wire harness side and ground.
TOOL:
Test probe, 2 pack 07ZAJ-RDJA 110
CONNECTION: Yellow(+) - ground (-)
STANDARD: Battery voltage
If there is battery voltage, the relay coil line is normal.
If there is no voltage, inspect the following:
- Loose or poorly connected connector
- Open circuit in the Black/white wire between the
ignition switch and starter/charging relay
- Open circuit in the Yellow wire between the starter/
charging relay and ECM
CONTINUITY INSPECTION
Remove the starter/charging relay (page 6-8).
Connect an ohmmeter to the following relay [1]
connector terminals.
CONNECTION: A- C
Connect a 12 V battery to the following relay connector
terminals.
CONNECTION: D - E
There should be continuity when the battery is
connected and there should be no continuity when the
battery is disconnected.
If the above inspection is abnormal, replace the starter/
charging relay.
[1]
E
C
[1]
[1]