Starter System Inspection; Ckp Sensor Line Inspection; Stator Inspection - Honda PCX150 2013 Service Manual

CKP LINE INSPECTION
Remove the luggage box (page 2-25).
Disconnect the CKP sensor 6P (Black) connector [1].
Turn the ignition switch ON and engine stop switch "0".
Measure the voltage between the CKP sensor 6P
(Black) connector of the ECM side and ground.
CONNECTION: White/red (+) - ground (-)
White/blue(+) - ground (-)
White/black(+) - ground (-)
Blue/yellow(+) - ground (-)
STANDARD: 5-10 V
Measure the voltage between the CKP sensor 6P
(Black) connector of the ECM side.
CONNECTION: Brown/black(+) - Blue/green (-)
STANDARD: Battery voltage
If there is standard voltage, the CKP sensor lines are
normal.
If there is no voltage, inspect the following:
- Loose or poor contacts of related terminal
- Open circuit in the wire harness between the ECM
and CKP sensor connector
- Faulty ECM
STATOR INSPECTION
Disconnect the ECM 3P (Black) connector (page 4-49).
Measure the resistance at the ECM 3P (Black)
connector [1].
CONNECTION: Red/yellow - Red/white
Red/yellow - Red/blue
Red/white - Red/blue
STANDARD: 0.03- 0.20
n
(20
°c1sa
°F)
If there is standard value, stator is normal.
If the value is abnormal at any connection, inspect the
following:
- · Loose or poor contacts of related terminal
- Open circuit in the wire harness between the ECM
and stator
[1]
ELECTRIC
White/
blue Wh' 1
: ~ ~~t T !{~
Blu;;~1own/
green Blue/ black
yellow
Red/white
1