Evap Canister Removal/Installation - Honda PCX150 2013 Service Manual

FUEL SYSTEM
Check the resistance between the solenoid valve side
of the EVAP purge control solenoid valve 2P (Black)
connector [1] terminals.
STANDARD: 30 - 34
Q
(20 °C/68 °F)
If the resistance is out of specification, replace the
EVAP purge control solenoid valve.
REMOVAL/INSTALLATION
Remove the front cover (page 2-15).
R '13
Disconnect the following from the EVAP canister [1 ]:
- EVAP canister drain hose [2]
- EVAP canister-to-fuel tank hose [3]
- Canister-to-EVAP purge control solenoid valve hose
[4]
Remove the EVAP canister by releasing the groove
from the frame.
Installation is in the reverse order of removal.
[1]