Honda PCX150 2013 Service Manual page 334

FRONT WHEEL/SUSPENSION/STEERING
Apply fork fluid to the lip of a new oil seal [1].
Install the oil seal
Drive the oil seal into the fork slider using the special
with its marked side
tools.
facing up.
TOOLS:
[2] Driver
[3] Attachment, 45 x 50 mm
07749-0010000
07946-6920100
Install the oil seal stopper ring [1] into the stopper ring
groove on the fork slider.
Apply fork fluid to a new dust seal [2] lip.
Do not tap the dust
Install the dust seal until it is fully seated.
seal lip too hard.
Install the fork pipe [1] into the fork slider [2].
If removing the fork piston ring [1] from the fork piston
[2], install a new fork piston ring to the fork piston
groove.
Make sure that the
Install the rebound spring [3] and fork piston into the
fork piston ring is
fork pipe.
seated in the
groove.
17-14
[2]
[3]
I\
qt
t
[1]
[2]
[3]
[2]