Ignition Coil Removal/Installation; Ignition Timing - Honda PCX150 2013 Service Manual

.•. ,.·
REMOVAL/INSTALLATION
Remove the left side cover (page 2-8).
Disconnect the spark plug cap.
Release the wire band boss [1].
Disconnect the ignition coil wire connectors [2]/[3].
Remove the mount bolts [4] and ignition coil [5].
Installation is in the reverse order of removal.
• The ignition timing cannot be adjusted since the
ECM is factory preset.
It is not necessary
Remove the four radiator mounting bolts and move it so
to disconnect the
that the cooling fan is visible (page 9-7).
water hoses from
the radiator.
Start the engine, warm it up to normal operating
temperature and stop it. ·
Read the
instructions for
timing light
operation.
• Never allow the cooling fan to come in contact with
the radiator while the engine is running, or the
radiator will be severely damaged.
Connect the timing light [1] to the spark plug wire.
Start the engine and let it idle (1,700 ± 100 rpm).
The ignition timing is correct if the index mark [2] on the
radiator base aligns with the "F" mark [3] on the cooling
fan.
If the ignition timing is incorrect, replace the ECM with a
new one (page 4-49) and recheck .
IGNITION SYSTEM