Headlight - '13 Model; Bulb Removal/Installation; Headlight Inspection; Headlight Removal/Installation - Honda PCX150 2013 Service Manual

LIGHTS/METERS/SWITCHES
HEADLIG
21-6
L)
BULB REMOVAL/INSTALLATION
Pull the dust cover [1].
Turn the headlight bulb [2] counterclockwise and
remove it from the headlight case.
Disconnect the bulb from the 3P connector [3].
I
NOTICE
I
Avoid touching the halogen headlight bulb. Finger prints
can create hot spots that cause a bulb to break.
Installation is in the reverse order of removal.
• Install the dust cover with its "TOP" mark [4] facing
up.
HEADLIGHT INSPECTION
Disconnect the ECM SP connector (page 4-49).
Turn the ignition switch ON and engine stop switch "O".
Measure the voltage between the ECM SP connector
[1] of the wire harness side and ground.
CONNECTION: Green/orange(+) - ground(-)
STANDARD: Battery voltage
If there is battery voltage, the headlight line is normal.
If there is no voltage, inspect the following:
- Blown HEADLIGHT fuse (10 A)
Loose or poor contacts of related terminal
Open circuit in the Green/orange wire between the
headlight and ECM
Open circuit in the Blue or White wire between the
headlight and dimmer switch
Open circuit in the Black/red wire between the
dimmer switch and fuse box
Faulty dimmer switch (page 21-24)
REMOVAL/INSTALLATION
Remove the front cover (page 2-15).
Disconnect the headlight 6P connector [1 ].
Remove the bolts [2] from the headlight unit [3].
Remove headlight unit while releasing the bosses [4]
from the frame grommets.
Installation is in the reverse order of removal.
[1]
[1]
Green/orange
[2]