Honda PCX150 2013 Service Manual page 277

DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
Hook the shoe spring [1] ends to the clutch shoe holes
with their long ends [2] facing the center holes and short
ends [3] facing the neighboring shoe holes as shown.
Install the E-clips
Install the plate [1] and new E-clips [2].
with their open side
facing out as
shown.
CLUTCH/DRIVEN PULLEY
Assemble the following:
- Driven pulley assembly [1]
- Driven face spring [2]
Spring seat [3]
- Clutch assembly [4]
Set the clutch spring compressor [1] over the clutch/
driven pulley assembly aligning the bosses of the
compressor with the holes of the clutch.
TOOL:
[1] Clutch spring compressor 07LME-GZ40201 or
07960-KM10008
(U.S.A. only)
Be careful not to
Compress the driven face spring while aligning the
damage the driven
cutout of the driven face threads with the drive plate
face threads.
hole and install the clutch/driven pulley nut.
[1]
[3]
[2]
[1]
[2]
[ 3 ] ~
[1]
1