Front Hub, Steering Knuckle, King Pin; Disassembly; Reassembly - Taylor-Dunn C0-T50-80 Service And Parts Manual

C0-T50-80

FRONT HUB, STEERING KNUCKLE, KING PIN

WARNING
This section is one section of a complete service manual. Before starting any procedure,
read all warnings and instructions that are located in the Service Guidelines chapter.
It is recommended that if a wearable component is replaced on one side of a vehicle, the same components should
be replaced on the other side of the vehicle.
This procedure assumes that the front axle component has been removed from the vehicle. Refer to the component
assembly removal instructions for details and warnings regarding the removal and installation procedure.

Disassembly

1: Remove the brake caliper. Refer to Brake section
for instructions.
2: Remove the hub cap cover bolts (1), hub cap (2),
and gasket (3). Note: The gasket will have to be
replaced.
3: Remove the adjustor jam nut (4), lock washer
(6), adjustor nut (5), washer (8), and the outer
bearing (9).
4: Remove the hub assembly (10, 11, 12,
13,14,15,16).
5: If required, remove the brake rotor mounting bolts
(13) and remove the rotor (12).
6: If required, remove the seal (15) and inner
bearing (16). Note: If the seal is removed, it must
be replaced.
7: Remove the king pin retaining bolt (18).
8: Remove the king pin cap (19) and push the king
pin up and out of the axle beam.
9: Remove the steering knuckle (17) and thrust
bearing (22).
MC-T50E-02

Reassembly

1: Thoroughly clean and inspect all parts.
2: If the hub seal was removed, it must be replaced.
3: Use a new hub cap gasket.
4: Pack the thrust bearing and wheel bearings with
grease before reassembly.
5: Reassemble in reverse order of disassembly.
6: Lubricate the king pin bushings after assembly is
complete.
7: Tighten the king pin retaining bolt per torque
listed in the Hardware Torque table at the end of
this section.
8: Use thread locking compound 94-430-07 on the
rotor bolts and tighten the rotor bolts per torque
listed in the Hardware Torque table at the end of
this section.
9: Tighten the hub cap bolts per torque listed in the
Hardware Torque table at the end of this section.
10: Refer to Adjust Front Wheel Bearings for wheel
bearing adjustment procedure.
Front Axle
Page 33