Table of Contents
Advertisement
The detail of the 'Status(Flash -> Current)' is as follows.
'Update-Status'
Applicable
No need
Waiting
Waiting(w---)
NG(Unsupported)
NG(Inapplicable - FW)
NG(Inapplicable - HW)
NG(ioctl error) *1)
NG(flash read error) *1)
NG(Unsupported HBA)
NG(Device Busy) *1)
*1) Retry the command to recover the possible temporary error.
For error messages when executing command, refer to [Error message] in the section
'hfcmcref-Online update of the firmware'.
Meaning
Firmware online update is applicable.
Hitachi Gigabit Fibre Channel Adapter hardware has already
updated by this version of the update file. You do not need to
execute online update.
Firmware update operation is running now. You are now
waiting to complete the operation. If the hfcmgr command
version lower than 8.0 is used, or an Adapter except 16G
Adapter is used, this message will be displayed.
Firmware update operation is running now and waiting for its
completion.
If the hfcmgr command version higher than or equal to 8.0
and the 16G Adapter are used, this message will be
displayed.
The firmware does not support firmware online update
function. You have to transfer the FLASH-ROM data by off-
line.
Specified firmware includes the update information which is
not applicable by on-line. You have to transfer the FLASH-
ROM data by off-line.
Specified firmware includes the hardware setting which is not
applicable by on-line. You have to transfer the FLASH-ROM
data by off-line.
Error occurred when executing ioctl.
Error occurred when reading FLASH-ROM.
This Gigabit Fibre Channel boaord does not support firmware
online update function. You have to transfer the FLASH-
ROM data by off-line.
Failed to open device file.
78
Advertisement
Table of Contents
