Table of Contents
Advertisement
Additional World
wwn_of_hba
Wide Port
Name
LOGIN DELAY
login_delay_time
TIME
PRE CONFIGURE
pre_configure
(*1) This range varies according to F/W version. If the version is newer than 2x0800, the range
is '0-FFFF', and the version is older than 2x0800, the range is '0-FF'.
(*2) This parameter can be set in HBA driver and hfcbios. If the both parameters are enabled,
the parameter in the HBA driver will be used. So if you want to use the parameter in hfcbios,
please remove the setting in the HBA driver.
(*3) Windows:｢hfcutil｣, Linux:｢hfcddutil｣
(*4) If the N+M Cold Standby function is enabled, the function will be effective after next reboot.
When the function is effective, WWPN and Pre-configure variable of the HBA will be under the
control of the Hitachi Compute Blade system.
(WWPN)
All 0
0-60 (sec)/default
Default
(3sec)
Enable/Disable
Disable
134
It is possible to refer
and change the content
of Additional WWPN
used by the Pre-
configure function.(*4)
When it is necessary to
delay the LOGIN
process to the device at
FC-SW cascade
connection etc., this
setting specifies the
Delay Time.
When the Pre-configure
function is used after
HotPlug is executed, it
sets it to "
Enable".(*4)
Advertisement
Table of Contents
