Table of Contents
Advertisement
[Example2] Set Luid scan mode of hfcldd0 to "enable" to check as shown below:
(hfcmgr version RHEL6: higher than or equal to 8.12, RHEL7: higher than or equal to 9.11,
Windows: higher than or equal to 8.13)
# ./hfcmgr -b hfcldd0 ls enable
Time:xxxx/xx/xx xx:xx:xx
Succeeded.
You need reboot system to reflect setting changes to the system.
# ./hfcmgr -b hfcldd1
Time:xxxx/xx/xx xx:xx:xx
------------------------------------------------------------
WWPN:50000870005e40fc Device:hfcldd0
------------------------------------------------------------
BIOS
Boot Priority
LUID scan mode
Priority Target WWN
----------------------------------------------------------------------------
HIGH 1 50060e8012000101 0000 Type3
2 0000000000000000 0000 -
3 0000000000000000 0000 -
4 0000000000000000 0000 -
5 0000000000000000 0000 -
6 0000000000000000 0000 -
7 0000000000000000 0000 -
LOW
8 0000000000000000 0000 -
Spinup Delay
Forced Default Parameter : disable
Additional WWPN
Pre Configure
#
[LinkUp]
: disable
: disable
: enable
LUN
LUID
LUID data
60060e80120001005040000100001002
-
-
-
-
-
-
-
: disable
: 2000000000000010
: disable
48
Advertisement
Table of Contents
