Table of Contents
Advertisement
14
No such file.
15
Not support, LPAR mode is
shared.
16
Not support, LPAR mode.
17
Unused
18
Not support, E-Option is disable.
19
Input WWPN not configured in
hfcldd.conf.
20
Nothing WWPN configured in
hfcldd.conf.
21
WWPN is not found at HBAAPI.
22
No such <WWPN>.
23
The adapter port has already
isolated.
24
No Adapter port.
25
Access busy, please try again
later.
26
Please input full path.
Input WWPN is already
27
configured in hfcldd.conf
【Linux】
Input WWPN is already
configured in registry.
【Windows】
28
Unused
29
File is not opened.
30
File format illegal.
31
Unused
32
Unused
33
Application lock error.
【Windows】
34
This Firmware version does not
support hot swap feature of SFP
Transceiver.
35
The adapter port status is
CHECK-STOP.
36
Check adapter mode is error.
【Windows】
37
The adapter port does not awake
isolation mode. 【Windows】
38
Unused
39
Input option is not support
operation.(<Device>)
40
Unused
No assigned file existing
Check if the file exists.
Not supported on the LPAR manager (shared
FC)
Not supported on the LPAR manager
-
Not supported. E-option is not available.
The input WWPN is not defined in
/etc/hfcldd.conf. Since the port individual
setting is not defined for the assigned WWPN,
this command is not necessary.
None of WWPN is defined in /etc/hfcldd.conf.
Since none of the port individual setting is
defined, this command is not necessary.
WWPN is not existed in HBAAPI.
Wait for a while and retry
No assigned WWPN adapter existing
Check WWPN of the adapter.
The adapter port is already isolated.
Check port status using hfcmgr -sfp
No adapter port existing
Check if the adapter is correctly set.
The hfcmgr function already in operation.
Re-execute after a while.
Assign the absolute path.
Since the value assigned for the new WWPN is
already used for the other adapter port, no
change is available.
Check the new WWPN.
-
Failed to open file. Retry the command again.
File format is invalid.
-
-
Failed to lock driver resources.
Wait for a while and retry.
Firmware does not support SFP hot-swap.
Update HBA firmware to the latest version.
Specified adapter port is Check-Stop state.
Check port status.
Specified adapter port is not the status which
is available in SFP hot-swap.
Check adapter status using hfcmgr –sfp
Failed to recover SFP.
Wait for a while and retry
-
Specified option is not supported.
Specified option is not applicable in single port
settings.
-
93
【Windows】11
【Linux】12
【Windows】12
【Linux】13
【Windows】13
【Linux】14
15
16
【Windows】14
【Linux】17
【Windows】15
【Linux】18
【Windows】16
【Linux】19
【Windows】17
【Linux】20
【Windows】28
【Linux】21
【Windows】18
【Linux】22
【Windows】19
【Linux】23
24
【Windows】21
【Linux】25
26
27
28
29
30
26
【Windows】27
【Linux】38
【Windows】29
【Linux】31
30
31
32
33
34
Advertisement
Table of Contents
