Hitachi GVX-CC64GxBX series User Manual page 70

[Detailed description]
Table Detailed description of hfcmgr –b
Item of display (Assigned parameter)
Description
BIOS (bi)
Enables or disables HBA BIOS. Set to "enable" to use by the boot path.
Boot Priority (bp)
Enables the boot device list. Set to "enable" to assign priority on the boot
device.
Boot device list (bd)
Registers the boot device (WWPN and LUN) for the priority assigned in the
boot device list.
hfcmgr version RHEL6: higher than or equal to 8.12, RHEL7: higher
than or equal to 9.11, Windows: higher than or equal to 8.13:
Display the LUID information.(Refer to the following)
Type1,Type3 : LUID data types
LUID
Invalid
Display the information of LUID
LUID data
N/A : Unusable because the card type is under 8Gbps.
Boot device list (bd)
Registers the boot device (WWPN and LUN) for the priority assigned in the
boot device list.
hfcmgr version RHEL6: higher than or equal to 8.12, RHEL7: higher
than or equal to 9.11, Windows: higher than or equal to 8.13:
Display the LUID information.(Refer to the following)
Spinup Delay (sd)
Sets to "enable" to insert the spinup waiting time of max. 5 minutes until the
disk becomes ready.
Persistent Bindings (pb)
Sets to "disable" when the persistent binding function is needed to disable.
This parameter is not displayed for 16G Fibre Channel Adapters.
Forced Default Parameter (fd)
Sets to "enable" to direct the driver to use the default value ignoring the set
value of this tool.
Additional WWPN (wn)
Can refer to or change the information set to Additional WWPN used by the
Pre-configure function of Hitachi Compute Blade. (*2)
Pre Configure (pc)
Sets to "enable" to use the Pre-configure function after HotPlug is executed.
(*2)
(*1)The value can be set from 0 to FF when the driver version is under 2x0800, while the
value can be set from 0 to FFFF when the driver version is equals to 2x0800 or more.
(*2) If the N+M Cold Standby function is enabled, the function will be effective after next
reboot. When the function is effective, WWPN and Pre-configure variable of the HBA will be
under the control of the Hitachi Compute Blade system.
- : unacquired or not supported
: Not supported on the device
N/A : Unusable because the card type is
under 8Gbps.
49
Default Settable value
value
disable enable
disable
disable enable
disable
priority: 1-8
wwn: all 0 wwn: (WWPN)
lun: 0 lun: 0-FFFF (*1)
(display only)
(display only)
priority: 1-8
wwn: all 0 wwn: (WWPN)
lun: 0 lun: 0-FFFF (*1)
disable enable
disable
enable enable
disable
disable enable
disable
all 0 (WWPN)
disable enable
disable