Table of Contents
Advertisement
(Step 2) Turn off Automap to enable this configuration information to check.
It is not yet translated into the driver operation at this time.
Figure Sample of hfcmgr –pb automap setting
# ./hfcmgr -pb automap off
Time:xxxx/xx/xx xx:xx:xx
Succeeded.
You need reboot system after remake a ramdisk image to reflect parameter changes to the system.
# /opt/hitachi/drivers/hba/hfcmgr -pb
Time:xxxx/xx/xx xx:xx:xx
Automap
: off
--------------------------------------------------------
WWPN: 5000087000300130 Device:hfcldd0
--------------------------------------------------------
TargetID
: 000
TargetWWPN : 50060e8000427810
TargetWWNN : 50060e8000427810
--------------------------------------------------------
(Step 3) Reboot after updating the RAMDISK image to translate into the driver.
WWPN: 5000087000300020 Device:hfcldd1
--------------------------------------------------------
TargetID
: 000
TargetWWPN : 50060e8000427810
TargetWWNN : 50060e8000427810
#
● The procedure for deleting Persistent Bindings is shown below:
(Step 1) Turn Automap back to ON to delete the configuration information.
Figure Sample of hfcmgr –pb delete execution
# ./hfcmgr -pb delete
Do you execute it? (y/n) > y
Time:xxxx/xx/xx xx:xx:xx
Succeeded.
You need reboot system after remake a ramdisk image to reflect parameter changes to the
system.
# /opt/hitachi/drivers/hba/hfcmgr -pb automap on
Time:xxxx/xx/xx xx:xx:xx
Succeeded.
You need reboot system after remake a ramdisk image to reflect parameter changes to the
system.
#
(Step 2) Reboot after updating the RAMDISK image to translate into the driver.
[LinkUp]
[LinkUp]
71
Advertisement
Table of Contents
