Table of Contents
Advertisement
Display or Set the Boot Information
[Function]Display or set the boot information
[Syntax]
<Display> hfcmgr -b [<logical-device-name>]
<Set> hfcmgr -b <logical-device-name> <options>..
<options>
bi {enable|disable}
bp {enable|disable}
ls {enable|disable}
bd priority <PRIORITY> wwn <WWPN> lun <LUN>
sd {enable|disable}
pb {enable|disable}
fd {enable|disable}
wn <Additional WWPN>
pc <enable|disable>
(*1) This parameter is not available for 16G Fibre Channel Adapters.
(*2) This parameter is supported from the following hfcmgr version.
・RHEL6: higher than or equal to 8.12
・RHEL7: higher than or equal to 9.11
・Windows: higher than or equal to 8.13
[Example1] Set HBA BIOS of hfcldd1 to "enable" to check as shown below:
(hfcmgr version RHEL6: lower than 8.12, RHEL7: lower than 9.11, Windows: lower than 8.13)
Figure Sample of hfcmgr –b setting or display
# ./hfcmgr -b hfcldd1 bi enable
Time:xxxx/xx/xx xx:xx:xx
Succeeded.
You need reboot system to reflect setting changes to the system.
# /opt/hitachi/drivers/hba/hfcmgr -b hfcldd1
Time:xxxx/xx/xx xx:xx:xx
--------------------------------------------------------
WWPN:50000870003021e0 Device:hfcldd1
--------------------------------------------------------
BIOS
Boot Priority
Target WWN
-------------------------------------
1 50060e8000c3f386
2 0000000000000000
3 0000000000000000
4 0000000000000000
5 0000000000000000
6 0000000000000000
7 0000000000000000
8 0000000000000000
Spinup Delay
Persistent Bindings
Forced Default Parameter : disable
Additional WWPN
Pre Configure
#
# BIOS
# boot priority
# Luid scan mode (*2)
# spinup delay
# persistent bindings (*1)
# forced default parameters
# additional wwpn
# pre-configured
[LinkUp]
: enable
: disable
LUN
Priority
00
HIGH
00
00
00
00
00
00
00
LOW
: disable
: disable
: 0000000000000000
: disable
47
# boot device
Advertisement
Table of Contents
