Table of Contents
Advertisement
Reset Delay Time
(-p rd)
This parameter specifies the time before processing the next SCSI command after a reset (Target Reset,
etc.) command succeeded. The parameter is set to the optimum value for a general purpose, so usually
this parameter does not need to be changed. In Windows 2012 and Windows 2012 R2, the driver ignores
this parameter and behaves as if it is set to 0 second.
Machine Check Retry Count
This parameter specifies maximum permissive number of hardware failures before the adapter port become
blocked. If 0 is set to this parameter, the driver does not block the adapter port by a hardware failure. The
parameter is set to the optimum value for a general purpose, so usually this parameter does not need to be
changed.
Preferred AL-PA Number
If AL (Arbitrated Loop) connection type is set on a FC path between Hitachi Fibre Channel Adapter and the
device attached to it, the driver uses this parameter as preferred ALPA (Arbitrated Loop Physical Address)
on loop initialization phase. The parameter is set to the optimum value for a general purpose, so usually this
parameter does not need to be changed.
Reset Timeout
(-p rt) [Linux only]
This parameter specifies the time out value in seconds of a Target Reset command.
The parameter is set to the optimum value for a general purpose, so usually this parameter does not need to
be changed.
Abort Timeout
(-p at) [Linux only]
This parameter specifies the time out value in seconds of an Abort Task Set command.
The parameter is set to the optimum value for a general purpose, so usually this parameter does not need to
be changed.
Abort Restrain
(-p ar) [Linux only]
Inhibit issuing Abort Task Set command. Usually, this parameter not need to be changed.
Allowed
(-p al) [Linux only]
This parameter specifies the minimum permissive retry number of a SCSI command. The parameter is
available on disk devices, but ignored on tape devices.
Target Reset Mode
(-p tr) [RHEL5 only]
This parameter specifies whether the driver executes Target Reset command to the device or not.
The parameter is set to the optimum value for a general purpose, so usually this parameter does not need to
be changed.
LUN Reset Delay Timer
(-p lt) [Linux only]
This parameter specifies the time before processing the next SCSI command after a reset (LUN Reset, etc.)
command succeeded.
The parameter is set to the optimum value for a general purpose, so usually this parameter does not need to
be changed.
Scatter/Gather List
(-p sc) [Windows only]
This parameter specifies the number of memory lists per IO command, for all devices.
The parameter is set to the optimum value for a general purpose, so usually this parameter does not need to
be changed.
MSCS Mode
(-p ms) [Windows only]
If Microsoft Cluster Service (MSCS) is used on Windows Server 2003, enable this parameter. If
JP1/HiCommand Dynamic Link Manager Software (HDLM) is installed, or Windows Server 2008 is used,
this parameter is not necessary.
(-p mc) *Displayed as "Machine Check"
(-p pa) *Displayed as "Preferred AL-PA"
164
Advertisement
Table of Contents
