Combination With Ms6 Modules; Commissioning; Safety - Festo MSE6-C2M Manual

Commissioning

1 Interface module or network-scanner/bus
master
2 User program in the machine controller
3 Network-specific configurator
Fig. 3 System configuration with MSE6-C2M-...-M and 3 CPX I/O modules (maximum configuration)
5.4

Combination with MS6 modules

The product can be extended on the left and right side with service unit components of the MS6
series.
Information on operating and assembly è Instructions for energy efficiency module MSE6-C2M-IN,
www.festo.com/spareparts
6 Commissioning
6.1

Safety

The product is equipped with a pneumatically-piloted proportional-pressure regulator and a down-
stream shut-off valve. The shut-off valve is pneumatically piloted and is open in a normal position.
When input pressure P1 is applied, the product automatically regulates the outlet pressure in the fol-
lowing cases to the last parameterised power-on target pressure (default setting 10 bar):
– Switch on of operating voltage until the connection is successfully made with the high-order con-
troller.
– Interruption of the network communication with correspondingly set system parameters
– Stopping of the higher-order controller (see manufacturer's specifications), e. g. in the case of
transmission of control programs, parameters, configuration data.
In the basic state, the module regulates the output pressure to the preset Power-On target pressure
when the shut-off valve is open. In the event of undervoltage in the operating voltage or the load
14
4 Energy efficiency module MSE6-C2M-...-M
5 CPX I/O modules with CPX-Extension series
2 connection
Festo — MSE6-C2M — 2019-03