Chapter 3. Operating Instructions; Flowmeter Display/Keypad - GE PanaFlow MV80 User Manual

Chapter 3. Operating Instructions

Chapter 3. Operating Instructions
After installing the PanaFlow Vortex Flowmeter per the instructions in the previous chapter, you are ready to begin
operation. The sections in this chapter explain the display/keypad commands and meter start-up and programming. The
meter is ready to operate at start up without any special programming. To enter parameters and system settings unique
to your operation, see the following pages for instructions on using the setup menus.

3.1 Flowmeter Display/Keypad

The flowmeter digital electronics enable you to set, adjust and monitor system parameters and performance. A full
range of commands are available through the display/keypad. The LCD display provides 2 x 16 characters for flow
monitoring and programming. The six push-buttons can be operated in non-hazardous environments with the enclosure
cover removed, In hazardous environments, the explosion-proof cover must remain in place and the keypad operated
with a hand-held magnet positioned at the side of the enclosure (see Figure 51 below).
ENTER
EXIT
PanaFlow™ MV
Figure 51: Magnetic Keypad Operation
PanaFlow™ MV80 & MV82 User's Manual 51