Troubleshooting
Problem: My RMC-1 won't respond to the remote control or the front panel controls.
Reason: Your RMC-1 has no power.
•
Confirm that the rear panel Power switch in turned On.
•
Confirm that the RMC-1 is plugged into an active outlet.
•
Check main fuse in the RMC-1.
•
Check internal fuses in the RMC-1.
Problem: My RMC-1 won't respond to the remote control (but the front panel
controls work fine).
Reason: Your remote control isn't working.
•
Confirm that your remote control has good batteries in it.
•
If you're using an IR eye or repeater, confirm that it is configured correctly and located in a
position where it isn't blocked or being flooded by another IR light source.
Problem: My RMC-1 takes a long time to start up.
Problem: When I turn on the rear panel Power switch, my RMC-1 turns On, goes
through a startup routine, then returns to Standby mode; this takes too long.
Reason: You have the Standby mode on your RMC-1 set to Use Least Power so the RMC-1
has to boot up every time you turn it on.
•
Set the Standby mode to Video Remains On.
Problem: When I use the Mode Up/Down buttons on the remote control or the front
panel, Reference Stereo Mode isn't there.
Reason: Reference Stereo Mode has to be configured in the Setup Menu.
•
In the Setup Menu, configure the Input you're using to use Reference Stereo as it's default
mode. (For each input, you can set separate default modes for 2 channel and surround sound
signals; the default setting for both is "Last Used".
Problem: The Standby button on my RMC-1 blinks whenever I use any remote control
near it, even the one for some other piece of equipment; is something wrong?
Reason: Because the RMC-1 can act as a repeater for signals from any remote control, it listens to all
IR remote control signals, and the Standby button blinks whenever the RMC-1 is receiving any remote
control signal.
•
This is normal.
Troubleshooting
Page 90