Emotiva RMC-1 Preliminary page 61

The RMC-1 Menu System
If you chose Dirac, you will be sent to the Dirac Live Menu.
If you choose to manually configure a preset, you will be prompted to choose Preset 1 or Preset 2,
and the following settings will be available for EACH preset.
Name
The Name setting allows you to set an alphanumeric "human friendly" name for each Preset.
Distance
The Distance setting will present you with a list of speakers, and allow you to manually enter a
distance measurement for each.
Size
The Size screen will enable you to configure the sizes, crossover frequencies, and crossover slopes
for your speakers, the configuration of your Rear Surround speakers, and the configuration of your
subwoofers.
For each type of speaker you set to Small, you will be able to set a Crossover Frequency between
40 Hz and 200 Hz in increments of 10 Hz.
Levels
The Levels screen allows you to adjust the relative level of each speaker by up to +/- 12 dB in
0.5 dB increments, and provides a pink noise test tone to help you perform SPL measurements.
The test tone can be set to three different levels (Low - 65 dB, Medium - 75 dB, and High - 85 dB),
or can be disabled if you prefer to use your own test signal source.
Note: The actual sound level at which the test tones will play in your listening room will depend
on the gain of your amplifiers and the efficiency of your speakers. The SPL values shown for the
different test signal output levels are estimates based on typical amplifier gain and speaker
efficiency; always select the setting that produces the appropriate level with your equipment.
Page 55