Emotiva RMC-1 Preliminary page 58

The RMC-1 Menu System
Front IR Blaster
Use this check box to disable the front panel IR blaster.
Front IR In
Check this box to disable the front panel IR Input.
Note: When the front panel IR Input is disabled, the remote control will NOT function unless an
external IR remote sensor ("eye) is used.
USB Audio UAC2
By default , the USB Stream Input on the RMC-1 operates as a USB Audio Class 1 device.
This enables it to accept USB audio at sample rates up to 24/96k from most devices,
including most phones, and most computers, without requiring the user to install extra
drivers. By enabling USB Audio Class 2 (UAC2) operation, the USB Stream Input will accept
USB audio up [NEED DETAILS]
Standby
Use this option to enable the RMC-1's Video on Standby feature.
Selecting Video Remains On will configure the RMC-1 to use its Video on Standby Mode. When
this mode is selected, the RXMC-1 will continue to pass video and audio from the selected input
source to the display, and will allow you to change the Input source, even when the XMC-1 is in
Standby Mode. The XMC-1 uses slightly more power when in Standby Mode if Video on Standby
Mode is enabled.
Selecting Lowest Power will configure the RMC-1 to use its lowest power Standby Mode. In this
mode, video and audio will NOT be passed to the display when the RMC-1 is in Standby Mode.
Note: When the RMC-1 is set to Video on Standby Mode, the RMC-1 Operating System remains
loaded when the RMC-1 is in Standby Mode. Because a significant portion of the start up time
on the RMC-1 is used to load the operating system, setting the RMC-1 to use Video on Standby
Mode will considerably shorten the amount of time it takes the RMC-1 to wake up from Standby
Mode.
Note: The start-up sequence on the RMC-1 is different depending on which Standby Mode you
have configured the RMC-1 to use.
In Lowest Power Mode, turning the XMC-1 On using the rear panel Power switch will cause it
to immediately enter Standby Mode (halo ring around the Standby button lit amber). Pressing
the Standby button will then cause the RMC-1 to load the RMC-1 Operating System and turn
fully On. The RMC-1 Operating System is loaded during this start up sequence, which may take
up to one minute. Pressing the Standby button when the RMC-1 is On will cause it to return to
Standby Mode (and unload the operating system).
Page 52