Emotiva RMC-1 Preliminary page 44

The RMC-1 Menu System
Speaker Presets
The RMC-1 has both Dirac Live automatic room correction, and two full banks of parametric
equalization that can be used for precise, detailed manual correction of room and system
frequency response. The Speaker Preset control allows you to select between the Presets that you
have configured in the Setup Menu; listed by the names you have assigned.
Note: Your RMC-1 is configured to use the Presets, and Dirac Live Automatic Room Correction,
from the Setup Menu, under Setup Speakers. Dirac Live is executed and configured from a
separate computer, which must have network access to connect to the RMC-1 and the Internet.
Surround Mode
The Surround Mode control is used to select which surround mode is used by the RMC-1 to
decode incoming audio. This control will present you with a list of available modes and allow you
to override the RMC-1's default selection. Selecting Auto on this menu will instruct the RMC-1 to
automatically choose the best decoding and processing modes based on the incoming audio.
Note: The RMC-1 will automatically detect the surround mode used by incoming audio and
only allow you to choose modes that are appropriate for the type of incoming signal that is
detected. If you set the RMC-1 to Auto, it will automatically select the best choice for a given
type of input signal; if you configure a specific mode, then that mode will be used; if you
configure the RMC-1 to Last Used, then it will use the same surround mode that you manually
selected the last time a similar type of input signal was detected.
Page 38