Emotiva RMC-1 Preliminary page 86

Connecting the RMC-1
6. Direct Mode & All Stereo Mode
Press one of these buttons to switch the RMC-1 into Direct Mode or All Stereo Mode without
cycling through the available choices on the menu.
7. Menu Navigation Buttons
Use the Select Button (center), and the Up, Down, Left, and Right buttons for navigating the front
panel and on-screen menus.
8. Info Button
If the Info screen is already displayed on the RMC-1 front panel display, pressing the Info button
will cause the Info screen to display momentarily on the OSD. If the Menu screen is displayed on
the RMC-1 front panel, pressing the Info button will cause the Info screen to display momentarily
on both the front panel display and the OSD (you will be returned to the Menu screen when the
Info screen times out).
9. Trims Adjustments
Use the Trims Adjustment buttons to temporarily adjust the levels on specific sets of speakers. The
Surround buttons act equally on all surround channels currently configured; the Height buttons
act equally on all height channels currently configured.
Note: These Trims are used to make temporary adjustments to speaker levels; for example,
to adjust the levels for a particular movie or disc. Since these settings are intended to be
temporary, they are NOT retained when you switch Inputs or change Speaker Presets, and they
are NOT retained when the RMC-1 is restarted. To make changes to speaker levels which will be
retained, use the Levels settings in the Speakers Preset section of the Setup Menu.
10. Zone 2 Power Button
Use the Zone 2 Power button to turn Zone 2 On and Off. Pressing this button once turns Zone 2
On; pressing it again turns Zone 2 Off.
Note: Pressing the Zone 2 Power button will turn Zone 2 On, even if the RMC-1 is in Standby
mode, and even if the RMC-1 is configured to use its Lowest Power Standby mode. However, if
you turn on Zone 2 while the Main Zone is Off, and while the RMC-1 is in Lowest Power Standby
mode, there will be a delay while the RMC-1's operating system is loaded. You can avoid this
delay by configuring your RMC-1 to use Video On Standby mode.
11. Tuner Control Buttons
Note: Once you have used the Tuner Direct Input button to select the RMC-1 tuner, the Tuner
Control buttons control operation of the tuner.
Press the AM/FM button to toggle between the AM and FM bands. Press the Station Up or Station
Down button to move to the previous/next preset station. Press the Seek Up or Seek Down button
to instruct the RMC-1 to seek to the previous/next received station. Press or hold the Tune Up or
Tune Down button to instruct the RMC-1 to manually seek a station by tuning up or down the
frequency band.
Page 80