Modifying Product Settings - Henny Penny Evolution Elite EEE-154 Operator's Manual

5-1. MODIFYING PRODUCT
SETTINGS
5-1
SECTION 5. PRODUCT PROGRAM MODE
This mode allows you to program the following:
• Change Product Name
• Assign Button
• Change Times & Temp
• Change Cook ID
• Alarms
• Quality Timers
1. Press and hold
display, followed by "ENTER CODE".
2. Enter code 1, 2, 3 (fi rst 3 product buttons). "PRODUCT"
and "PROGRAM" show in the displays, followed by
"SELECT PRODUCT' and "-P 1-" (ex: NUG).
Change Product Names
3. Use the
products, or press the desired product button.
4. Press  button and "NAME" shows in the left display
and the product (ex: NUGGETS) shows in the right display.
5. Press
Press a product button and the fl ashing letter changes to the
fi rst letter under the product button that was pressed. For
example, if
an "A".
Press the same button again and the fl ashing letter changes
to a "B". Press it again and fl ashing letter changes to a
"C". Once the desired letter shows in display, press
button to continue to next letter and repeat the procedure.
Press and hold the right X button to exit Program Mode, or
press
Assign Button
6. Press
display, along with the product (ex: NUGGETS). If this
product already has a product button assigned to it, that
LED will be lit. To assign other product buttons to that
product, press and hold the product button for 3 seconds
and that LED stays lit. To remove a product from a button,
press and hold the product button with a lit LED and the
LED goes out.
• Include in Filter Count (Global)
• Filter at X no. of loads (Mixed)
• Load Compensation
• Load Compensation Reference
• Full Heat
• PC Factor
button until "PROG" shows in the
and buttons to scroll through the 40

button and the fi rst letter in the name fl ashes.
is pressed, the fl ashing letter changes to
button to continue on to "COOK TIME".
button until "ASSIGN BTN" shows in the
Model EEE-153, 154
811