Henny Penny Evolution Elite EEE-154 Operator's Manual page 67

7-2. ERROR CODES
(Continured
DISPLAY CAUSE
"E-21" • Slow heat recovery • Have a certifi ed service technician check the fryer for
"E-22" "NO • Elements not
HEAT" heating
"CHECK
PWR CORD
AND
BREAKER"
"E-31" • Elements are up
"E-41", "E-46" • Programming
failure
"E-47" • Analog converter
chip or 12 volt
supply failure
"E-48" • Input system error
"E-54C" • Temperature input
error
"E-60" • AIF PC board not
communicating with back on again. If "E-60" persists, have connector between
control PC board
"E-93-A" • Autolift motor
"24 VDC malfunction or
SUPPLY failure
TRIPPED"
811
CORRECTION
correct voltage to the unit; have heat circuit checked; have
unit checked for loose or burnt wire
• Have power cord and heat circuit checked
• Lower elements completely back into the vat
• Press power button to vat off and back on again, if any
of the error codes, have the controls re-initialized; if error
code persists, have the control board replaced
• Press power button to vat off and back on again, if "E-47"
persists, have the I/O board, or the PC board replaced; if
speaker tones are quiet, probably I/O board failure; have
the I/O board replaced
• Have PC board replaced
• Turn switch to OFF, then back to ON; have control PC
board replaced if "E-54C" persists
• Press power button to turn vat off, wait 15 seconds, and turn
the PC boards checked; replace AIF PC board or control
PC board, if necessary
• If AutoLift feature is not operating, have each of the
Autolift motors checked
Model EEE-153, 154
7-4