Check/Replace Filter Drain Pan O-Rings - Henny Penny Evolution Elite EEE-154 Operator's Manual

3-17. CLEAN-OUT MODE
(Continued)
3-18. CHECK/REPLACE FILTER
DRAIN PAN O-RINGS
Figure 1
Figure 2
Figure 3
3-27
17. Thoroughly dry the vat with a towel, and then press the
button. Controls return to normal operations.
Make sure the inside of the vat, the drain valve opening,
and all the parts that come in contact with the new oil are
as dry as possible.
18. Make sure drain is closed and return fi lter pan assembly,
with new fi lter pad, to the fryer. Fill vat with oil following
Filling or Adding Oil instructions from Section 3-3.
To prevent oil leaking, and to keep fi ltering process operating
properly, the fi lter drain pan o-rings should be inspected for
nicks and tears at least every 3 months. Figure 1
1. Open the door, lift-up on the drain pan stop and pull-out the
fi lter drain pan assembly, using the handle on the drain pan.
Figures 2 & 3
This pan could be hot! Use protective cloth or glove, or
severe burns could result.
2. Visually check the 3 o-rings on the tube of the fi lter drain
pan for any cracks or breaks and replace if necessary.
3. To replace o-ring, use a small, fl at-bladed screwdriver, pry
up on o-ring and pull off of end of tube. Roll new o-ring
into notch on tube. Lubricate o-rings on fi lter tube with
fresh, cold oil and push fi lter drain pan into position.
Model EEE-153, 154
Figure 4

811