Product Program Mode; Modifying Product Settings - Henny Penny EVOLUTION ELITE EEG-241 Operator's Manual

SECTION 5: PRODUCT PROGRAM MODE
5-1.
MODIFYING
PRODUCT SETTINGS
March 2014
This mode allows you to program the following:
Change Product Name
•
Assign Button
•
Change Times & Temp
•
Change Cook ID
•
Alarms
•
Quality Timers
•
Press and hold
1.
display, followed by "ENTER CODE".
Enter code 1, 2, 3 (first 3 product buttons). "PRODUCT" and
2.
"PROGRAM" show in the displays, followed by "SELECT
PRODUCT' and "-P 1-" (ex: NUG).
Change Product Names
Use the ▲ and ▼ buttons to scroll through the 40 products, or press
3.
the desired product button.
Press ► button and "NAME" shows in the left display and the
4.
product (ex: NUGGETS) shows in the right display.
Press √ button and the first letter in the name flashes. Press a product
5.
button and the flashing letter changes to the first letter under the
product button that was pressed. For example, if
flashing letter changes to
an "A".
Press the same button again and the flashing letter changes to a "B".
Press it again and flashing letter changes to a "C". Once the
desired letter shows in display, press ► button to continue to next
letter and repeat the procedure.
Press and hold the right X button to exit Program Mode, or press ►
button to continue on to "COOK TIME".
Assign Button
Press ► button until "ASSIGN BTN" shows in the display, along
6.
with the product (ex: NUGGETS). If this product already has a
product button assigned to it, that LED will be lit. To assign other
product buttons to that product, press and hold the product button
for 3 seconds and that LED stays lit. To remove a product from a
button, press and hold the product button with a lit LED and the LED
goes out.
59
Include in Filter Count (Global)
•
Filter at X no. of loads (Mixed)
•
Load Compensation
•
Load Compensation Reference
•
Full Heat
•
PC Factor
•
button until "PROG" shows in the
is pressed, the