Henny Penny Evolution Elite EEE-154 Operator's Manual page 63

6-3. CLOCK SET
6-4. DATA LOGGING, HEAT
CONTROL, TECH, STAT,
AND FILTER CONTROL
MODES
811
1. Press and hold the
2", followed by, "SP PROG" and "ENTER CODE" show in
the display.
2. Press the button again and "CLK SET" and "ENTER
CODE" fl ash in the left display.
3. Enter code 1, 2, 3 (fi rst 3 product buttons).
4. "CS-1 ENTER DATE MM-DD-YY" fl ashes in the left
display. Use the product buttons to set the date in the right
display.
5. Press button and "CS-2 ENTER TIME" fl ashes in the
left display and the time fl ashes in the right display. Press
the or , or use product buttons, to change the time.
6. Press button and "CS-2 ENTER TIME" fl ashes in the
left display and "AM" or "PM" fl ashes in the right display.
Use the or
7. Press button and "CS-3 TIME FORMAT" fl ashes in
the left display and "12-HR" or "24-HR" shows in the right
display. Use the
time format or a 24 hour time format.
8. Press button and "CS-4 DAYLIGHT SAVING TIME"
fl ashes in the left display. Use the
choose daylight saving time for your area: 1.OFF; 2.US
(2007 & after); 3.EURO; or 4.FSA (US before 2007).
The Data Logging, Heat Control, Tech, Stat and Filter Control
Modes are advanced diagnostic and program modes, mainly for
Henny Penny use only. For more information on these modes,
contact the Service Department at 1-800-417- 8405 or 1-937-
456-8405.
Model EEE-153, 154
button for 5 seconds until "LEVEL
buttons to choose AM or PM.
or buttons to choose a 12 hour
or buttons to
6-11