Filter After - Henny Penny Evolution Elite EEE-154 Operator's Manual

5-1. MODIFYING PRODUCT
SETTINGS Continued)
5-3
Mixed Filter Tracking
Filter After X Number of Loads
13b. Press button until "FILTER AFTER..." fl ashes
in the left display along, and the number of cook cycles
between fi lters shows in the right display. Press the product
buttons, or the
0 to 99 loads. This needs set for each product.
>Load Compensation, Load Compensation
Reference, Full Heat, PC Factor<
14. Press button until "LD COMP" shows in the display,
along with the load compensation value. This automatical-
ly adjusts the time to account for the size and temperature
of the cooking load.
Press the product buttons, or the
change this value of 0 to 20.
15. Press button until "LCMP REF" shows in the display
along with the load compensation average temperature.
(if load compensation is set to "OFF", then "_ _ _" shows
in display and setting cannot be programmed) This is the
average cooking temperature for each product. The timer
speeds up at temperatures above this setting and slows
down at temperatures below this setting. Press the product
button, or the
16. Press button until "FULL HT" shows in the display
along with the full heat value in seconds, which means the
heat is on as soon as a timer button is pressed, for the pro-
grammed length of time. Press the product buttons, or the
and buttons, to change this value of 0 to 90
seconds.
17. Press button until "PC FACTR" shows in the display
along with the proportional temperature, which helps to
keep the oil from over-shooting the setpoint temperature.
Press the product buttons, or the
change this value of 0 to 50 degrees.
• Use button to go back to previous menu items.
• Press button when fi nished with the current product, to
return to the "SELECT PRODUCT" step.
• Press and hold
Mode.
Model EEE-153, 154
and buttons, to change this value of
and
and buttons, to change this value.
and
button to exit PRODUCT PROGRAM
buttons, to
buttons, to
811