Henny Penny Evolution Elite EEE-154 Operator's Manual page 51

5-1. MODIFYING PRODUCT
SETTINGS Continued)
811
To Change Times and Temperatures
7. Press button until "COOK TIME" shows in the
display, and then use the product buttons, or the
and buttons, to change the time in minutes and
seconds, to a maximum of 59:59.
8. Press button and "TEMP" shows in the display, along
with the preset temperature on the right side of the display.
Press the product buttons, or the
change the temperature. The temperature range is 190°F
(88°C) to 375°F (191°C).
Cook ID Change
9. Press button until "COOK ID" shows in the display
along with the product ID. For example, NUG would
be the ID for nuggets. Use the product buttons, or the
and buttons, to change the ID.
Alarms (1 & 2)
11. Press button until "ALRM 1" shows in the left
display, and an alarm time in the right display. Press the
product buttons, or the
alarm.
Ex., If a Cook Cycle was set at 3 minutes, and an alarm
was to go off after 30 seconds into the Cook Cycle, "2:30"
would be set in the display at this time. When the timer
counts down to 2:30 the alarm sounds.
After alarm time is set, press
shows in display, and a second alarm can be programmed.
Quality Timer (hold time)
12. Press button until "QUAL TMR" shows in the display
along with the preset holding time. Press the product
buttons, or the
time, up to 59:59.
Global Filter Tracking
Include in Filter Count
13a. Press button until "INCL IN FLTR CNT" fl ashes in
display along with "YES" or "NO". Using
buttons, change the display to "YES" if that product's Cook
Cycles are to be counted as part of the recommended fi lter
process. Set to "NO" if it is not to be included.
Model EEE-153, 154
and
and buttons, to set an
button and "ALRM 2"
and buttons,to adjust holding
buttons, to
and
5-2