Henny Penny Evolution Elite EEE-154 Operator's Manual page 65

7-1. TROUBLE SHOOTING GUIDE
(Continued)
Problem Cause
Oil foaming or boiling
over top of vat
Oil will not
drain from vat
Filter motor runs but
pumps oil slowly
Bubbles in oil during
entire fi ltering process
Control error code "E-31"
Filter motor will not run
811
• Water in oil
• Improper or bad oil
• Improper fi ltering
• Improper rinsing after
cleaning the vat
• Drain valve clogged
with crumbs
• Drain trough clogged
• Filter line connections loose
• Filter paper or pad
clogged
• Filter pan not completely
engaged
• Filter pan clogged
• Damaged O-ring on fi lter
line receiver on fryer
• Elements are up
• Power cord for vat #1
is not plugged-in
• Open circuit
• the thermal reset button on
the rear of the pump motor
is tripped
Model EEE-153, 154
Correction
• Drain and clean oil
• Use recommended oil
• Refer to fi ltering procedures
• Clean and rinse vat and then
dry thoroughly
• Open valve, force cleaning brush
through drain
• Remove right side panel and remove
plug from end of trough and clean
trough
• Tighten all fi lter line connections
• Change fi lter paper or pad
• Make sure fi lter pan return line is
pushed completely into the receiver on
the fryer
• Clean pan and change paper or pad
• Change O-ring
• Lower elements back into vat
• Plug power cord into receptacle
• Breakers in fryer tripped; open left door
and reset breaker on fryer
• Allow time for the motor to cool and
then, using a screwdriver, press hard
against the button until it clicks
7-2